Superchargers, parts accessories and maintenence

Image: 

SC oil syringe

$15.00

A syringe for filling SC12, SC14, and Ogura TX superchargers.

Price: $15.00

Smallport SC12 supercharger bearing

$50.00

This is a replacement bearing for the smaller smallport 10 PSI supercharger pulley.
I offer a proffesional rebuild service for these pulleys. I will pull the old bearing and replace it with a new one using bearing loctite and peening it in place as they are originally done.

EMail me if you are interested in having us service your supercharger.

Price: $50.00

Supercharger pulley SST (special service tool)

$65.00

This is the SST required for removing the supercharger pulley on most Ogura superchargers including the Toyota SC12 and SC14.
For more details on where it's needed see our SC12 service guide.
http://www.matrixgarage.com/content/sc12-service-guide
You will need this tool to properly torque the snout nut back on upon reassembly.
The Largeport SC12 typically has a 38mm pattern though I have seen two that used a snap ring instead.
The smallport typically uses a 35mm pattern.

Price: $65.00

SC12 4AGZE gasket kit

$45.00

This kit includes a gasket for the inlet, outlet and the bearing cap for the SC12 supercharger found on the 4AGZE.
 
 

Price: $45.00

SC12 supercharger service kit

$70.00

This kit contains everything that can be replaced on a largeport SC12 such as those found in the AW11 MR2.
1 supercharger pulley bearing
1 gearbox cover o-ring
1 copper washer for the dip stick tube
1 copper washer for the drain bolt
1 dip stick seal
1 inlet  flange gasket
1 outlet flange gasket
1 bearing cover gasket
 
 
 
There is a service guide here
http://www.matrixgarage.com/?q=content/sc12-service-guide
 

Price: $70.00

Largeport SC12 superchager pulley rebuild

$110.00

This is a service where you send me your supercharger pulley and I rebuild it.
This is a basic bare bones rebuild pulling the old bearing and inserting a new bearing. Inspecting the pulley and making sure it's good to go back into service.
The cost of the rebuild includes a new NSK or Nachi brand bearing.
I can bead blast the pulley for an additional $20
I can spray the pulley with truck bed liner for $20 more.
Instead of truck bed liner I can spray the pulley with ceramic coating. This is a very high temp very hard and durable coating.

Price: $110.00

Largeport SC12 superchager pulley bearing

$50.00

This is a replacement bearing for the USDM SC12 supercharger pulley.
I offer a proffesional rebuild service for these pulleys. I will pull the old bearing and replace it with a new one using bearing loctite and peening it in place as they are originally done.
We don't always have the same brand but it will always be a top name brand such as Nachi, NSK or Koyo.

Price: $50.00

Klubersynth oil for Ogura TX superchargers (1 liter)

$38.00

 

Ogura Clutch is the manufacturer for the Toyota SC12 and SC14 superchargers.
Aside from the housing casting the SC12 and SC14 are virtually identical to the TX12 and TX15

 

This is the reccomended oil for the Ogura TX series chargers.

Price: $38.00

courtesy of webmatter.de